Fire-lite ACM-8RF Control Relay Module Uživatelský manuál stáhnout pdf (Strana 24)

Appendix A: MS-5210UD Application Example #1

ACM-8RF PN 50362:C 03/21/01

Application Example #1

Zone Alarm Only Activation (no system status relays)

Program the MS-5210UD at Level 3 addresses 02 - 03 for the proper address

setting. The address selected must be the highest or maximum address value

selected on any annunciator or ACM-8RF connected to the EIA-485 port.

(Refer to the Programming Section of the MS-5210UD Instruction Manual).

For this example, only one relay per zone is required and the ACM-8RFs are

the only devices on the EIA-485 bus. Since only ACM-8RFs occupy the bus,

the address setting for them should be switch SW1 = 0 and switch SW2 = 1.

Enter this address into the MS-5210UD Level 3 addresses 02 - 03.

Since each ACM-8RF module contains eight relays, two ACM-8RF modules

are required for 10 zones. Refer to the following chart for switch settings:

Table 6 Settings for Zone Alarm Activation

MS-5210UD

Zone

ACM-8RF

Relay

Switch Settings

Z1 Relay 1

1st ACM-8RF

SW1=0; SW2=1 (Address ‘01’)

SW3-2 = ON; SW3-5 = ON

All other SW3s = OFF

SW4-1=ON; SW4-2=ON

Z2 Relay 2

Z3 Relay 3

Z4 Relay 4

Z5 Relay 5

Z6 Relay 6

Z7 Relay 7

Z8 Relay 8

Z9 Relay 1

2nd ACM-8RF

SW1=0, SW2=1 (Address ‘01’)

SW3-3 = ON; SW3-5 = ON

All other SW3s = OFF

SW4-1=ON; SW4-2=OFF

Z10 Relay 2

n/a Relay 3

n/a Relay 4

n/a Relay 5

n/a Relay 6

n/a Relay 7

n/a Relay 8

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Fire-lite ACM-8RF Control Relay Module Uživatelský manuál Strana 24

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Fire-lite ACM-8RF Control Relay Module